
antampatz
@antampatz
994
Following
106
Followers
36
Updates
829
Likes
111
Comments
274
Votes






147 days ago
Week 7— Knee Articulation Improvement
This week I made a small but worthwhile change to improve the knee articulation.
The knee assembly includes an internal joint that should allow for a deeper bend, but in the stock design it is intentionally limited. Each side of the joint has a small protrusion that catches on the central piece between them, preventing the hinge from travelling as far as it otherwise could. Presumably this was done to keep the movement under control and maintain the intended appearance, even if it comes at the cost of articulation.
The fix itself was very straightforward. I removed those protrusions from both sides of the joint, which allows the mechanism to hinge much more freely and gives the knee a noticeably greater range of movement.
It’s a simple modification, but a useful one, especially for a build where posing will matter. Since I’ve decided to keep the model fully articulated rather than fixing it in a single pose, improving movement where possible should make it easier to get stronger and more natural stances later on.
The comparison photos in this update show the difference between the modified and unmodified leg, and the improvement is quite clear. It’s a small change, but one that should make the finished build more flexible without requiring major reworking.


