GWCC Online
Sign Up
antampatz cover image

antampatz

@antampatz

Sci-Fi

994

Following

106

Followers

36

Updates

829

Likes

111

Comments

274

Votes

Week 3 — Preparation, Fit Adjustments & Early Decisions (Part 1: Marking & Fit Work) 1
Week 3 — Preparation, Fit Adjustments & Early Decisions (Part 1: Marking & Fit Work) 2
Week 3 — Preparation, Fit Adjustments & Early Decisions (Part 1: Marking & Fit Work) 3
Week 3 — Preparation, Fit Adjustments & Early Decisions (Part 1: Marking & Fit Work) 4
Week 3 — Preparation, Fit Adjustments & Early Decisions (Part 1: Marking & Fit Work) 5
Week 3 — Preparation, Fit Adjustments & Early Decisions (Part 1: Marking & Fit Work) 6
Week 3 — Preparation, Fit Adjustments & Early Decisions (Part 1: Marking & Fit Work) 7
Week 3 — Preparation, Fit Adjustments & Early Decisions (Part 1: Marking & Fit Work) 8
Sci-Fi

173 days ago

Week 3 — Preparation, Fit Adjustments & Early Decisions (Part 1: Marking & Fit Work)

This week focused on early preparation work and setting things up for a smoother build process later on.


I started by marking parts while they were still on the sprues using a fine marker. The intention here was to identify components that are visually identical but designated for opposite sides of the build (left/right) under different runner numbers. In many cases, these parts could likely be interchanged without causing issues, but marking them now provides a simple safeguard once they are removed from the runners.


I also began working on fit adjustments at this stage. Using drill bits, I carefully enlarged selected female connection points while the parts were still on the sprues. Bandai kits are typically engineered with very tight tolerances, and rather than relying on the common approach of cutting pegs at an angle to allow disassembly, I wanted to address this more cleanly and consistently.

This approach should allow for repeated dry fitting and disassembly without stressing or damaging the parts during later stages of the build.

  • STUDIO935
    S
    STUDIO935107 days ago

    The drill bit process looks good :p

    • antampatz
      A
      antampatz69 days ago

      Replying to STUDIO935

      @studio935, Thank you!

Followers