Jetto Hobby

All I could do this week was finalising the wheel hubs, relocating the mounting points of the wishbones and push rod linkages. Still have to re-design the drive-train housing for all these new points.

Issue: found out the belts were getting hot after a short burst of throttle. If it does get too hot, the PLA idler pulley will not last. Ordered aluminium idler pulley, should be here in 2-3 weeks time, then I have to get that belt tensioner re-designed when it arrives. I hope this does not cause too much delay on the project.

PS: This project has been so much fun but unfortunately it is not my full-time job. Have to squeeze out as much time as I can get to make sure I meet the submission deadline.