Carlos Navarro

Continuing with the carbon fiber work, I was going to add it to the spoiler, but the design made it quite difficult to install since it's two parts that came as a single piece. So I cut it in two. Once separated, I made patterns with masking tape and cut them out from the decal sheet, then applied them using the normal procedure. Finally, to join the pieces together again, I used two types of cyanoacrylate. First, I used the ultra-liquid type to glue the supports. I used this because it cuts quickly between the pieces, reducing the likelihood of going where you shouldn't. Second, I used the black cyanoacrylate to join other parts that needed filling in gaps. Being black, it blends in well with the carbon fiber.