Hiro Fukuda

For my second dry-fit attempt of the rear subframe, I used two additional parts to reinforce the assembly.

To lower the ride height on the left side, I installed both the front and rear spacers underneath the left wheel hubs. The right side was assembled according to the kit instructions.

Comparing the two setups, I think the lowered stance looks a bit too aggressive for a street-driven car. I'll probably add a 0.3 mm spacer above the hub assembly to create a little more clearance between the tires and the wheel arches.

The fully lowered setup may be better suited for a Pacchetto Tempesta build, or perhaps a BC conversion using 3D-printed parts.